Vehicle Speed Sensor (NV 3500)

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the electrical connector from the vehicle speed sensor.





3. Remove the following parts:
^ The bolt
^ The vehicle speed sensor
^ The O-ring seal


Installation Procedure





1. Coat a new O-ring seal with a thin film of transmission oil. Use Synchro-mesh Transmission Fluid GM P/N 12345349 or the equivalent.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the following parts:
2.1. The O-ring on the vehicle speed sensor assembly
2.2. The vehicle speed sensor assembly
2.3. The bolt
^ Tighten the bolt to 22 Nm (16 lb ft).





3. Install the electrical connector to the vehicle speed sensor.
4. Lower the vehicle.