Operation CHARM: Car repair manuals for everyone.

Oil Level Sensor: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement in Engine.
4. Disconnect the Engine Oil Level Switch harness connector.




5. Remove the Engine Oil Level Switch.

INSTALLATION PROCEDURE

NOTE: Refer to Component Tightening Notice

IMPORTANT: No sealant is required when installing a new Engine Oil Level Switch.




1. Install the Engine Oil Level Switch.

Tighten
Tighten the bolts to 13 N.m (115 lb in).




2. Connect the Engine Oil Level Switch harness connector.
3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
4. Fill the engine with oil. Refer to Engine Oil and Oil Filter Replacement in Engine.
5. Connect the negative battery cable.