Differential Assembly Installation

^ Tools Required
- J 36612 Bearing Installer (T, K1, and K2 models)
- J 36613 Bearing Installer Bearing Installer (K3 model)
- J 36513 Driver Handle
- J 36599 Sleeve Adjusting Wrench
- J 36615 Adjuster Plug Wrench (K3 model)
- J 36603 Side Bearing Cup Installer





1. For the T, K1, and K2 models, use the J 36513 and the J 36612 in order to install the bearings to the sleeves.
2. For the K3 model, use the J 36613 Bearing Installer in order to install the adjuster plug.
3. For the K3 model, install the new O-ring seal to the adjuster plug.





4. For the T, K1, and K2 models, use the and the J 36599 in order to install the sleeves to the carrier case.
5. For the K3 model, use the J 36615 in order to install the right sleeve to the carrier case. Use the J 36599 in order to install the adjuster plug.
6. Use the J 36603 with the J 36513 in order to install the side bearing cups.





7. Install the differential assembly to the carrier case half.
^ Place the differential assembly into the carrier case half which contains the pinion gear.
^ For T, K1, and K2 models, use the J 36599 in order to turn the left sleeve in until the backlash is felt between the ring and the pinion.





8. For the K3 model, use the J 36615 in order to turn the adjuster plug in until the backlash is felt between the ring and the pinion.
9. Remove the carrier case from the J 36599
10. Install the carrier case halves. Do not use sealer at this time. If the carrier halves do not make complete contact, use the J 36599 in order to back out the right sleeve.
11. Install the bolts.
^ Tighten the bolts to 47 Nm (35 ft. lbs.).