Shift Lever

Removal Procedure





1. Remove four plastic retainer plugs securing the shift boot retainer to the shift boot.
2. Remove eight screws securing the shift boot and insulator to the floor panel.
3. Remove the retainer and shift boot from the shift lever.





4. Remove the shift lever from the shift tower. Do not remove the shift lever adjusting nut.


Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the shift lever to the shift tower.
If required, use the shift lever adjusting nut to center the shift lever.
^ Tighten the shift lever nut to 47 Nm (35 ft. lbs.).





2. Position the retainer and shift boot onto the shift lever.
3. Install eight screws securing the shift boot and insulator to the floor panel.
^ Tighten the screws to 2 Nm (18 ft. lbs.).
4. Install four plastic retainer plugs securing the shift boot retainer to the shift boot.