Tamper Timer

Range: 0-600 Seconds
Use the tamper timer as part of the interactive procedure in order to allow the EVO/PASSLOCK (TM) Module to display the time remaining when in the tamper mode. The tamper timer starts when the ignition switch is turned to the RUN position and the EVO/PASSLOCK (TM) Module receives a PASSLOCK (TM) data voltage that is different from the last learned PASSLOCK (TM) data voltage. The tamper timer has a lockout timer of 10 minutes. The vehicle must remain in the tamper mode even if the ignition switch is turned from the RUN position to the OFF position during the 10 minute period, however the timer will reset to 0 and will start a new count.