Oil Pressure Sensor: Service and Repair

REMOVAL PROCEDURE

^ Tools Required
- J 25254-10A Oil Pressure Sensor Socket.





1. Disconnect the electrical connector from the engine pressure sensor / switch.
2. Hold the oil pressure sensor fitting with a wrench.
3. Remove the oil pressure sensor using J 25254- 10 A.





IMPORTANT: Note the alignment of the oil pressure sensor fitting prior to removal.

4. Remove the oil pressure sensor fitting, if necessary.

INSTALLATION PROCEDURE

^ Tools Required
- J 25254-10A Oil Pressure Sensor Socket.

NOTICE: Fastener Notice in Service Precautions.





1. Install the oil pressure sensor fitting, if removed.
1.1. Tighten the oil pressure sensor fitting to 15 Nm (11 ft. lbs.).

IMPORTANT: Do not tighten more than one turn.

1.2. Tighten the fitting until properly align.





2. Install the oil pressure sensor.
3. Hold the oil pressure sensor fitting with a wrench to prevent from turning.
^ Using J 25254-10A tighten the oil pressure sensor to 30 Nm (22 ft. lbs.).
4. Install the electrical connector.