Operation CHARM: Car repair manuals for everyone.
Home >> Chevy Truck >> 1999 >> K 2500 Suburban 4WD V8-454 7.4L VIN J SFI >> Repair and Diagnosis >> Steering and Suspension >> Steering >> Steering Column >> Service and Repair >> - With Column Shift >> Electronic Column Lock Module - Assemble

Electronic Column Lock Module - Assemble

ASSEMBLY PROCEDURE





1. Install the lock bolt spring (3) into the steering column housing assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column housing assembly (5).
4. Push the lock bolt assembly (4) into the steering column housing assembly (5) until the lock bolt assembly is flush with the steering column housing assembly (5).
5. Align the lock module assembly (2) with the steering column housing assembly (5).
Install the lock module assembly (2) onto the steering column housing assembly (5).





6. Screw the 3 pan head tapping screws (1) into the lock module assembly (2).
- Tighten the 3 pan head tapping screws to 7 Nm (62 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

7. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.
- Tighten the screws to 4.7 Nm (42 inch lbs.).
8. Install the key alarm connector (1) onto the lock module assembly (2).





9. Install the park lock cable (1) into the lock module assembly.
10. Place steering column lock cylinder set into the off position.
11. Place the shift lever clevis into the park position.
12. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly.
13. Inspect the park lock cable assembly by performing the following steps.
13.1. Insert the key into the ignition switch.
13.2. Place the steering column lock cylinder set in the OFF or the LOCK position. The gear shift lever must remain locked in the park position.
13.3. Place the steering column lock cylinder set in the RUN position.
13.4. Place the gear shift lever in the neutral position.
13.5. With the gear shift lever in the neutral position, the steering column lock cylinder set must remain out of the OFF or the LOCK position.
13.6. Place the gear shift lever in the park position.
13.7. Put the steering column lock cylinder set in the OFF or the LOCK position.
13.8. Remove the key from the ignition switch.
14. Install the upper head components.
pro multis · About Operation CHARM