Manifold Pressure/Vacuum Sensor: Service and Repair
MAP Sensor ReplacementREMOVAL PROCEDURE
1. Disconnect the MAP sensor electrical connector (4) from the MAP sensor (1).
2. Remove the two MAP sensor attaching bolts (1).
3. Remove the MAP sensor (2) from the intake plenum.
INSTALLATION PROCEDURE
1. Lubricate the seal on the MAP sensor vacuum port with clean engine oil.
2. Install the MAP sensor (2) into the intake plenum.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Secure the MAP sensor to the intake plenum with the two bolts (1).
Tighten
Tighten the bolts to 3.5 N.m (30 lb in).
4. Connect the MAP sensor electrical connector (4) to the MAP sensor (1).