Steering Column Trim Covers - Assemble - Export

- Tools Required
- J 41352 Modular Column Holding Fixture
- J 42640 Steering Column Anti Rotation Pin





1. Install the shift lever seal (2) onto the shift lever assembly (4).
2. Install the shift lever assembly (4) and secure it with the shift lever screw (3).

Notice: Refer to Fastener Notice in Service Precautions.

- Tighten the shift lever screw to 1.5 Nm (13 inch lbs.).





3. Install the upper trim cover (2) onto the steering column.
4. Screw the 2 TORX head screws (1) into the upper trim cover (2).
- Tighten the 2 TORX head screws to 1.5 Nm (13 inch lbs.).
5. Slide the shift lever seal onto the upper trim cover.





6. Install the lower trim cover onto the upper trim cover.
7. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
8. Tilt the lower trim cover up.
9. Align the shift lever seal into the trim covers.
10. Slide the lower trim cover forward until the locking tabs snap into the tab slots.





11. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).
- Tighten the 2 pan head tapping screws to 3.5 Nm (31 inch lbs.).
12. Install the tilt lever into the lower trim cover.





13. Remove J 42640 from the lower trim cover of the steering column.
14. Remove the steering column and J 41352 from the vise.