Front

The content of this article reflects the changes identified in TSB 05-03-08-006.

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the nuts (1) from the link bolt assemblies.
3. Remove the link bolts (3).
4. Remove the link assemblies (2).





5. Remove the insulator clamp bolts (3).
6. Remove the clamps (2).
7. Remove the stabilizer shaft (4).
8. Remove the insulators (1).
9. Inspect all of the parts for wear and damage.


Installation Procedure

Important: Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.





1. Install the insulators (1) to the stabilizer shaft (4).
2. Install the stabilizer shaft (4).
3. Install the clamps (2) over the insulators and the stabilizer shaft.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install insulator clamp bolts (3).
4.1. Tighten the bolts to 33 Nm (24 ft. lbs.) (15 series).
4.2. Tighten the bolts to 50 Nm (39 ft. lbs.) (25 series).





5. Install the link assemblies (2).
6. Install the link bolts (3).
7. Install the nuts (1) to the link bolt assemblies.
- Tighten the nut to 10 Nm (89 inch lbs.). Continue tightening the nut until 2-4 threads protrude above the nut.
8. Remove the safety stands.
9. Lower the vehicle.