Electronic Column Lock Module - Assemble

- Tools Required
- J 42759 Ignition Switch Connector Release Tool





1. Install the lock bolt spring (3) into the steering column tilt head assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column tilt head assembly (5).
4. Push the lock bolt assembly (4) into the steering column tilt head assembly (5) until the lock bolt assembly (4) is flush with the steering column tilt head assembly (5).
5. Align the electronic lock module assembly (2) with the steering column tilt head assembly (5).

Notice: Refer to Fastener Notice in Service Precautions.

6. Screw the 3 pan head tapping screws (1) into the electronic lock module assembly (2).
- Tighten the 3 pan head tapping screws to 7 Nm (62 inch lbs.).





7. Insert J 42759 into the electronic lock module assembly (1) and slide the ignition and key alarm switch assembly (2) in.





8. Install the key alarm connector (1) onto the electronic lock module assembly (2) in the following way:
8.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
8.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector locks into place.
8.3. Install the passkey connector into the electronic lock module assembly (2).
9. Install the steering column tilt head components. Refer to Steering Column Tilt Head Housing -Assemble - Off Vehicle (Column Shift) or Steering Column Tilt Head Housing - Assemble - Off Vehicle (Floor Shift) or Steering Column Tilt Head Housing - Assemble - Off Vehicle (Export).