Ignition & Key Alarm Switch - Assemble

- Tools Required
- J 42759 Ignition Switch Connector Release Tool





1. Insert 142759 into the electronic lock module assembly (1) and slide the ignition and key alarm switch assembly (2) in.





2. Install the key alarm connector (1) into the electronic lock module assembly (2).
2.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
2.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
2.3. Install the passkey connector into the electronic lock module assembly (2).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





4. Attach the wire harness assembly (1) to the steering column with new wire harness strap (2).
5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Export).