Camshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

1. Disconnect the electrical connector from the Camshaft Position (CMP) sensor.

IMPORTANT: Clean the area around the CMP sensor before removal in order to prevent debris from entering the engine.

2. Remove the CMP sensor retaining bolt.
3. Remove the CMP sensor.

INSTALLATION PROCEDURE

1. Install the CMP sensor.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the CMP sensor retaining bolt.

Tighten
Tighten the bolt to 25 N.m (18 lb ft).

3. Connect the CMP sensor electrical connector.