SIR Steering Wheel Module Coil - Assemble - Export

1. Align the block tooth on the steering column shaft assembly (1) to the 12 o'clock position.
2. Place the ignition switch in the LOCK position.





3. Install the wave washer (1) onto the steering column shaft assembly (2).
4. If you are installing the existing inflatable restraint steering wheel module coil, you must center the inflatable restraint steering wheel module coil first. Refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift) or Inflatable Restraint Coil Centering - Off Vehicle (SRS).





Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.

5. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
6. Slide the new inflatable restraint steering wheel module coil (4) onto the steering column shaft assembly (2).
7. Firmly seat the snap ring (3) into the groove on the steering column shaft assembly (2).
8. Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).





9. Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
10. Attach new wire harness strap (2) to the wire harness assembly (1) and the steering column.
11. Install the upper and lower trim covers. Refer to Steering Column Tom Covers - Assemble - Off Vehicle (Column Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Export).