Instrument Panel (IP) - Trim Pad Replacement - Upper

REMOVAL PROCEDURE




1. Set the air flow control to the instrument panel (IP) vent position if equipped with air conditioning (A/C).
2. Disable the SIR system. Refer to Disabling the SIR System in SIR.
3. Apply the parking brake to prevent the vehicle from moving.
4. Move the shift lever all the way down (if the transmission is automatic).
5. Tilt the steering wheel to the full down position.
6. Remove the IP cluster trim plate bezel. Refer to Bezel Replacement - IP Cluster.
7. Remove the end panels. Left is shown, right is similar.
8. Remove the right side air outlets.




9. Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes.
10. Remove the windshield pillar garnish moldings.
11. Remove the bolts retaining the pad to IP assembly.




12. Disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim pad.




13. Remove the trim pad from the assembly.

INSTALLATION PROCEDURE




1. Install the trim pad to the IP assembly.




2. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim pad.

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the trim pad retaining screws.

Tighten
Tighten the trim pad retaining screws to 2 N.m (18 lb in).

4. Install the windshield pillar garnish moldings.




5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
6. Install the right side air outlets.




7. Install the end panels. Left is shown, right is similar.
8. Install the IP cluster trim plate bezel.
9. Tilt the steering wheel to the normal driving position.
10. Move the shift lever to the park position (if the transmission is automatic).
11. Disengage the parking brake.
12. Enable the SIR system.