Ignition Coil and ICM Replacement

IGNITION COIL AND ICM REPLACEMENT

REMOVAL PROCEDURE






1. Remove the spark plug wires from the ignition control module assembly.
The ignition coils and the spark plug wires are numbered in order to aid assembly.
2. Disconnect the electrical connector and the vacuum hoses from the purge solenoid valve.






3. Remove the nut and the purge solenoid valve.






4. Remove the two bolts and one stud retaining the ignition control module assembly.
5. Remove the ignition control module assembly.

INSTALLATION PROCEDURE






1. Install the ignition control module assembly to the engine with one bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the remaining bolt and the stud.

Tighten
Tighten the bolts and the stud to 27 N.m (20 lb ft).






3. Install the purge solenoid valve and the nut.

Tighten
Tighten the nut to 27 N.m (20 lb ft).

4. Connect the electrical connector and the vacuum hoses to the purge solenoid valve.






5. Install the spark plug wires to the ignition control module assembly.
The ignition coils and the spark plug wires are numbered in order to aid assembly.