Electric Park Lock Module - Assemble

- Tools Required
- J 41352 Modular Column Holding Fixture
- J 42640 Steering Column Anti Rotation Pin





1. Snap the electric park lock (2) onto the electronic lock module assembly (1).





2. Install the black connector (2) into the electric park lock (1).





3. Install the upper trim cover (2) onto the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

4. Screw the 2 TORX(R) head screws (1) into the upper trim cover (2).
- Tighten the 2 TORX8 head screws to 1.5 Nm (13 inch lbs.).





5. Install the lower trim cover onto the upper trim cover in the following way:
5.1. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
5.2. Tilt the lower trim cover up.
5.3. Slide the lower forward until the locking tabs snap into the tab slots.





6. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).
- Tighten the 2 pan head tapping screws to 3.5 Nm (31 inch lbs.).





7. Remove J 42640 from the lower trim cover.
8. Remove the steering column and J 41352 from the vise.