Inflatable Restraint Instrument Panel Module Replacement
REMOVAL PROCEDURECAUTION:
^ Refer to SIR Caution in Service Precautions.
^ Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the passenger knee bolster.
3. Remove the Connector Position Assurance (CPA) retainer (2) from the inflatable restraint IP module harness connector.
4. Disconnect the inflatable restraint IP module connector (1).
5. Remove the clip that retains the inflatable restraint IP module harness to the instrument panel (3).
6. Remove the two bolts (2) that retain the inflatable restraint IP module (3) to the instrument panel carrier.
7. Push out from the back side in order to remove the inflatable restraint IP module from the instrument panel.
INSTALLATION PROCEDURE
1. Install the inflatable restraint IP module (3).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the two bolts (2) that retain the inflatable restraint IP module to the instrument panel carrier.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
3. Install the inflatable restraint IP module connector (1).
4. Install the connector position assurance (CPA) retainer (2).
5. Install the clip that retains the inflatable restraint IP module harness to the instrument panel (3).
6. Install the passenger knee bolster.
7. Enable the SIR system.