Keyless Entry Transmitter Battery: Service and Repair

TRANSMITTER BATTERY REPLACEMENT

REMOVAL PROCEDURE




Under normal use, the battery in the transmitter will last about 2 years. For battery replacement, use a Panasonic(R) 3 volt, type CR2032, or the equivalent.
1. In order to open the transmitter case, perform the following steps:
1.1. Insert a dime between the 2 halves of the transmitter near the key ring hole.
1.2. Twist the dime.




2. Remove the battery.

INSTALLATION PROCEDURE




1. Install the battery with the (+) positive side down.
2. In order to close the transmitter case, perform the following steps:
2.1. Align the top and bottom covers.
2.2. Snap together the top arid the bottom covers.
2.3. Inspect the operation of the transmitter.