Electronic Column Lock Module - Assemble

1. Install the electronic lock module assembly (2) onto the steering column housing assembly (3).

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 3 pan head tapping screws (1) into the electronic lock module assembly (2).
- Tighten the 3 pan head tapping screws to 7 Nm (62 inch lbs.).





3. Slide the ignition and key alarm switch assembly (3) into the electronic lock module assembly (1).





4. Push the key alarm connector (1) into the electronic lock module assembly (2).
5. Rotate the key alarm connector 90 degrees so that the key alarm connector locks into place.
6. Install the passkey connector into the electronic lock module assembly (2).





7. Place steering column lock cylinder set into the OFF position.
8. Place the shift lever clevis into the PARK position.
9. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.
10. Install the turn signal cancel cam, bearing thrust washer. Refer to Turn Signal Cancel Cam, Bearing Thrust Washer- Assemble.