Steering Shaft, Lower Bearing & Jacket - Assemble - Export

Notice: Refer to Fastener Notice in Service Precautions.





1. Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 new TORX head screws (1).
- Tighten the 4 TORX head screws to 17 Nm (13 ft. lbs.).





2. Install the steering shaft assembly (1) into the steering column support assembly (2) and the steering column jacket assembly (3).





3. Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
3.1. Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
3.2. Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.





Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.

4. Install the turn signal and multifunction switch assembly (2) onto the steering column housing assembly.
5. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction switch assembly (2).
- Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).
6. Install the electronic lock module assembly. Refer to Electronic Column Lock Module - Assemble - Off Vehicle.