Engine Sight Shield Replacement
Engine Sight Shield ReplacementRemoval Procedure
1. Loosen the engine sight shield bolt.
2. Remove the engine sight shield from the sight shield retainer.
3. If removal of the engine sight shield retainer is required, disconnect the cruise control cable clip from the retainer.
4. Disconnect the accelerator control cable clip from the retainer.
5. Remove the engine sight shield retainer bolts and the retainer, if required.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the engine sight shield retainer and the bolts, if required.
^ Tighten the engine sight shield retainer bolts to 5 Nm (44 inch lbs.).
2. Install the accelerator control cable clip to the retainer.
3. Install the cruise control cable clip to the retainer.
Notice: Use care when installing the engine sight shield to avoid contacting the Manifold Absolute Pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
4. Install the engine sight shield to the retainer.
5. Tighten the engine sight shield bolt.
^ Tighten the engine sight shield bolt to 10 Nm (89 inch lbs.).