85. Engine Coolant Air Bleed Pipe Installation - Four Point Pipe

1. Install the gaskets onto the engine coolant air bleed pipe.
Position the gasket O-ring seal onto the nipple portion of the pipe.

Important: Route the knock sensor wire harness over the top of the engine coolant air bleed pipe. The pipe and knock sensor wire harness should be installed in a manner as to allow the removal of the wire harness without requiring the removal of the pipe.





2. Install the pipe and gaskets onto the cylinder heads.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the pipe bolts.
Tighten the pipe bolts to 12 Nm (106 inch lbs.).





4. Install the hose and clamp (2) onto the pipe.