Heat Only

REMOVAL PROCEDURE




1. Remove the instrument panel (IP) bezel. Refer to Bezel Replacement - IP Cluster in Instrument Panel, Gauges and Console.
2. Remove the radio.
3. Remove the HVAC control assembly by firmly depressing and holding the retaining tabs. Slide the assembly forward.




4. Disconnect the temperature and the mode cables from the back of the HVAC control assembly.
5. Disconnect the electrical connection from the HVAC control assembly.
6. Remove the HVAC control assembly.

INSTALLATION PROCEDURE




1. Connect the electrical connection to the HVAC control assembly.
2. Connect the temperature and the mode cables to the back of the HVAC control assembly.




3. Install the HVAC control assembly to the IP carrier until you hear an audible snap.
4. Install the radio.
5. Install the IP bezel. Refer to Bezel Replacement - IP Cluster in Instrument Panel, Gauges and Console.