Front Position Sensor Replacement - Electronic Suspension

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the sensor harness connector from the vehicle harness connector.
3. Remove the wheel speed sensor wire from the real time damping (RTD) sensor bracket.
4. Remove the (RTD) sensor link bracket bolt from the upper control arm.
5. Remove the bolt from the frame.
6. Remove the position sensor from the vehicle.


Installation Procedure





1. Install the position sensor on the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the bolt to the frame.
^ Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install the (RTD) sensor link bracket bolt to the upper control arm.
^ Tighten the bolt to 9 Nm (80 inch lbs.).
4. Install the wheel speed sensor wire to the real time damping (RTD) sensor bracket.
5. Connect the sensor harness connector to the vehicle harness connector.
6. Lower the vehicle.