4L60-E - Automatic Transmission

Flywheel to Torque Converter Bolt Replacement
Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the starter.
3. Remove the converter housing access plug.
4. Mark the converter and flywheel for proper alignment for installation.





5. Remove the right side transmission cover bolt.
6. Remove the right side transmission cover.





7. Remove the flywheel to converter bolts through the starter opening.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the flywheel to converter bolts. Hand start the bolts.
^ Tighten the bolts to 63 Nm (46 ft. lbs.).





2. Install the right side converter cover.
3. Install the right side converter cover bolt.
^ Tighten the right side converter cover bolt to 12 Nm (106 inch lbs.).
4. Install the starter motor.





5. Install the converter housing access plug.
6. Lower the vehicle.