Shift Lever - With Tow/Haul Switch

Shift Lever Replacement- On Vehicle (With Tow/Haul Switch)

Removal Procedure






1. Remove the steering column trim covers.
2. Roll back the seal on the shifter lever (1) until the TORX (R) head screw (2) is exposed.
3. Remove the TORX (R) head screw (2).
4. Remove the knee bolster.






5. Remove the nuts (1) from the knee bolster deflector bracket.






Notice: During removal of the steering column the wire harness retaining clip must be removed and reinstalled after installing the steering column or damage may occur to the wire harness.

6. Remove the wiring harness retaining pin (4) from the instrument panel.
7. Remove the wire straps and open the harness insulation to gain access to the electrical wiring.
8. Remove the wiring from the electrical connector.
9. Remove the shift lever (1).

Installation Procedure






1. Install the shift lever (1).
2. Connect the shifter electronic connector.
3. Install the wire straps to the harness.






4. Install the harness retaining pin (4) to the instrument panel.

Notice: Refer to the Fastener Notice.






5. Install the knee bolster deflector bracket and nuts (1). Tighten the nuts to 9 Nm (80 in. lbs.).
6. Install the knee bolster.
7. Install the TORX (R) head screw. Tighten the screw to 1.5 Nm (13 in. lbs.).
8. Roll the seal over the TORX (R) head screw.
9. Install the steering column trim covers.