Rear EVAP Fuel Tank Pipe Installation Procedure

1. Remove the caps from the fuel sender EVAP pipe and the fuel tank roll over valve.
2. Connect the rear EVAP pipe (1) to the fuel sender (2), the fuel tank roll over valve (3), and the fuel tank clips (6).




3. Install the fuel tank.
4. Lower the vehicle.
5. Refill the fuel tank.
6. Connect the negative battery cable.
7. Tighten the fuel filler cap.
8. Inspect for leaks.
8.1. Turn ON the ignition for 2 seconds.
8.2. Turn OFF the ignition for 10 seconds.
8.3. Turn ON the ignition.
8.4. Inspect for fuel leaks.