Shift Lever Replacement
Shift Lever ReplacementRemoval Procedure
1. Remove the 3 console nuts and the console (If equipped).
2. Remove the shift lever from the shifter.
3. Pull back the carpet to access the screws.
4. Remove the screws securing the boot to the panel.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the screws securing the boot to the panel.
Tighten the screws to 2 Nm (18 inch lbs.).
2. Install the shift lever to the shifter.
3. Install the console and the 3 console nuts (If equipped).
Tighten the nuts to 2 Nm (18 inch lbs.).