C1295

DTC C1295






Circuit Description
DTC C1295 identifies open brake switch circuitry that prevents the brake switch input to the EBCM from changing states while applying the brake. An open brake switch circuit will result in a modified ABS entrance criteria and possibly false settings of excessive wheel speed variation codes (C1225 thru C1228).

Conditions for Running the DTC
This DTC can set anytime that the EBCM is powered.

Conditions for Setting the DTC
The brake switch input voltage is between 2.2 volts and 5.0 volts for 2.0 seconds.

Action Taken When the DTC Sets
ABS remains functional.

Conditions for Clearing the DTC
^ The condition responsible for setting the DTC no longer exists and the Scan Tool Clear DTCs function is used.
^ 100 drive cycles pass with no DTCs detected. A drive cycle consists of starting the vehicle, driving the vehicle over 16 km/h (10 mph), stopping and then turning the ignition OFF.

Diagnostic Aids
Thoroughly inspect the wiring and the connectors. An incomplete inspection of the wiring and the connectors may result in a misdiagnosis, causing a part replacement with the reappearance of the malfunction. The following are possible causes of the malfunction:
^ All brake lamps open.
^ Open brake lamp ground.
^ Brake switch input circuit open.
^ The brake switch is misadjusted.
^ An internal EBCM malfunction. If an intermittent malfunction exists, refer to Testing for Intermittent and Poor Connections.

Test Description
The number below refers to the step number on the diagnostic table.
4. Tests the brake switch input circuit for an open or high resistance.