Right

Valve Stem Oil Seal and Valve Spring Replacement- Right

- Tools Required
- J 8062 Valve Spring Compressor
- J 37979 Valve Spring Compressor Adaptor
- J 36017 Valve Guide Seal Remover
- J 38232 Valve Seal Installer

Removal Procedure





1. Remove the right hand cylinder head.

Caution:
- Wear safety glasses in order to avoid eye damage.
- Compressed valve springs have high tension against the valve spring compressor. Valve springs that are not properly compressed by or released from the valve spring compressor can be ejected from the valve spring compressor with intense force. Use care when compressing or releasing the valve spring with the valve spring compressor and when removing or Installing the valve stem keys. Falling to use care may cause personal Injury.

Important: Keep the valve train components together and identified in order for proper installation in their original position.

2. Compress the valve spring using the J 8062 and the J 37979.
3. Remove the valve keepers using a magnet or small screwdriver.
4. Slowly release the J 8062 from the valve spring assembly.





5. Remove the retainer and the inner and the outer valve springs. Both the inner and outer valve springs have a top (large-pitch) and bottom (small pitch) end. The small-pitch end is installed towards the valve spring seat.

Notice: Do not damage the valve guide. Remove any burrs that have formed at the key groove by chamfering the valve stem with an oil stone or a file.





6. Remove the valve seal (1) using the J36017.
7. Remove the spring seat.





8. Remove the valve.
9. Remove the remaining valve springs and valves.

Installation Procedure





1. Install the spring seat to the cylinder head.
2. Install the new valve seals using the J 38232. Fully seat the seals on the valve guides.





3. Apply engine oil to the valve stem. Install the valve.

Important: Both the inner and outer valve springs have a top (large-pitch) and bottom (small pitch) end. Install the small-pitch end toward the valve spring seat.

4. Install the springs.
5. Install the retainer.

Caution:
- Wear safety glasses in order to avoid eye damage.
- Compressed valve springs have high tension against the valve spring compressor. Valve springs that are not properly compressed by or released from the valve spring compressor can be ejected from the valve spring compressor with intense force. Use care when compressing or releasing the valve spring with the valve spring compressor and when removing or installing the valve stem keys. Failing to use care may cause personal injury.





6. Compress the valve spring using the J 8062 and the J 37979
7. Install the valve keepers.
8. Slowly release the J 8062 from the valve/spring assembly.





9. Lightly tap the valve stem tip with a plastic faced hammer and inspect for proper valve keeper seating.
10. Install the right hand cylinder head.