Operation CHARM: Car repair manuals for everyone.

70. Primary Timing Chain Installation

Primary Timing Chain Installation





1. Verify that the keyway (2) on the crankshaft is positioned properly.





2. Install the crankshaft sprocket (2) to the crankshaft (1).





3. Verify that the Knock-pin (1) on the right intake camshaft is aligned with the match mark (2).





4. Install the right primary sprocket to the intake camshaft with the RH mark facing forward.

Notice: Refer to Fastener Notice in Service Precautions.





5. Secure the sprocket (1) with the bolt while holding the intake camshaft (2) with a wrench.
Tighten the bolt to 80 Nm (57.5 ft. lbs.).





6. Install the timing chain tensioner (2). Secure with the nut.
Tighten the nut to 27 Nm (19.5 ft. lbs.).





7. Install the primary timing chain to the primary right intake sprocket by aligning the right silver link (1) on the chain with the mark (2) on the sprocket.





8. Apply oil to the inside of the idler sprocket and install the sprocket by aligning the left silver link (1) with the mark (2) on the idler sprocket.





9. Install the primary timing chain to the crankshaft sprocket by aligning the yellow link (2) on the chain with the mark (3) on the sprocket.
10. Apply oil to the bearing of the idler sprocket.





11. Install the primary timing chain to the idler sprocket (1) and secure the sprocket to the engine block with the bolt.
Tighten the bolt to 45 Nm (32.5 ft. lbs.).





12. With the latch (2) of the tensioner adjuster returned and the plunger (3) pushed back into the body, insert a retainer (paper clip or similar tool) (1) into the set hole. After inserting the pin, make sure the plunger will not come out.





13. Install the tensioner adjuster (1) to the engine block and tensioner. Secure with the 2 bolts.
Tighten the bolt to 11 Nm (7.5 ft. lbs.).
14. Remove the retainer (3) from the tensioner.





15. Install the timing chain guides (1, 3).
Tighten the bolts to 9 Nm (6.5 ft. lbs.).





16. Verify that each timing mark is aligned properly.
17. Install the left secondary timing chain and tensioner.
18. Install the engine front cover.
19. Install the spark plugs.