Operation CHARM: Car repair manuals for everyone.

Compressor Mounting Bracket Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Remove the power steering pump and A/C compressor drive belt.
3. Disconnect the power steering Pressure switch connector.
4. Remove the 3 bolts from the power steering pump and position the pump out of the way.
5. Disconnect the compressor clutch electrical connector.
6. Remove the 3 bolts (1) that secure the A/C compressor and position the compressor aside.
7. Remove the 4 bolts and the A/C compressor mounting bracket from the vehicle.

INSTALLATION PROCEDURE




1. Install the A/C compressor mounting bracket to the vehicle. Secure the bracket with the 4 bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the compressor to the vehicle. Secure the compressor with the 3 bolts (1).

Tighten
Tighten the compressor mounting bolts to 23 N.m (17 lb ft).

3. Connect the compressor clutch electrical connector.
4. Install the power steering pump and secure with the 3 bolts.

Tighten
Tighten the power steering pump bolts to 25 N.m (18.5 lb ft).

5. Connect the power steering Pressure switch connector.
6. Install the power steering pump and A/C compressor drive belt.
7. Connect the negative battery cable.