Heated Oxygen Sensor (HO2S) 1 Replacement
TOOLS REQUIRED^ J 29533-A/BT-8127 Oxygen Sensor Wrench
^ J 39194-B Heated Oxygen Sensor Wrench
HO2S BANK 1 SENSOR 1
NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Service Precautions.
Removal Procedure
IMPORTANT: The Heated Oxygen Sensor (HO2S) may be difficult to remove at temperatures of more than 48°C (120°F). In order to prevent damage to any threads in the exhaust manifold, allow the exhaust system to cool down before attempting to remove the HO2S.
Camshaft Position (CMP) Sensor:
1. Disconnect the HO2S1 electrical connector.
2. Remove the HO2S1 (1) from the exhaust manifold with the J 29533-A/B T-8127, J 39194-B, or an equivalent.
Installation Procedure
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
IMPORTANT: The new sensor comes with an antiseize coating on the sensor threads. Take precautions in order to prevent the removal of any of the antiseize coating prior to installation. If the sensor was removed and is being reinstalled, an antiseize compound must be applied to the threads before installation.
Camshaft Position (CMP) Sensor:
1. Install HO2S1 (1) to the exhaust manifold with the J 29533-A/BT-8127, J 39194-B, or an equivalent.
Tighten
Tighten HO2S sensor to 45 N.m (32 lb ft).
2. Connect the HO2S 1 electrical connector (1).
HO2S BANK 2 SENSOR 1
NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Service Precautions.
Removal Procedure
IMPORTANT: The Heated Oxygen Sensor (HO2S) may be difficult to remove at temperatures of more than 48°C (120°F). In order to prevent damage to any threads in the exhaust manifold, allow the exhaust system to cool down before attempting to remove the HO2S.
1. Disconnect the HO2S 1 electrical connector.
2. Remove the HO2S 1(2) from the exhaust manifold (1) with the J 29533-A/BT-8127, J 39194-B, or an equivalent.
Installation Procedure
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
IMPORTANT: The new HO2S 1 comes with an antiseize coating on the sensor threads. Take precautions in order to prevent the removal of any of the antiseize coating prior to installation. If the sensor was removed and is being reinstalled, an antiseize compound must be applied to the threads before installation.
1. Install HO2S 1(2) to the exhaust manifold (1) with the J 29533-A/BT-8127, J 39194-B, or an equivalent.
Tighten
Tighten HO2S sensor to 45 N.m (32 lb ft).
2. Connect the HO2S 1 electrical connector.