Electronic Column Lock Module - Assemble

Electronic Column Lock Module-Assemble-Off Vehicle (Floor Shift)





1. Install the lock bolt spring (3) into the steering column housing assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column housing assembly (5).
4. Push the lock bolt assembly (4) into the steering column housing assembly (5) until the lock bolt assembly is flush with the steering column housing assembly (5).
5. Align the electronic lock module assembly (2) with the steering column housing assembly (5). Install the electronic lock module assembly (2) onto the steering column housing assembly (5).

Notice: Refer to Fastener Notice in Service Precautions.

6. Screw the 3 pan head tapping screws (1) into the electronic lock module assembly (2).
- Tighten the 3 pan head tapping screws to 7 Nm (62 inch lbs.).





7. Install the ignition and key alarm switch assembly (3) onto the electronic lock module assembly (2) and secure by using the 2 tapping screws.
- Tighten the screws to 4.7 Nm (42 inch lbs.).
8. Install the key alarm connector (1) onto the electronic lock module assembly (2).
9. Install the steering column jacket.