Heating, Ventilation and Air Conditioning
| A/C Compressor Low Pressure Switch | 5 N.m |
| A/C Compressor Mounting Bolts | 50 N.m |
| A/C Compressor Shaft Nut (V7) | 17.5 N.m |
| A/C Refrigerant Filter Retaining Nuts | 15 N.m |
| Accumulator Clamp Screw/Bolt | 10 N.m |
| Accumulator to Evaporator Fitting | 28 N.m |
| Air Distributor Duct Mounting Screw/Bolt | 1.9 N.m |
| Air Inlet Assembly Mounting Stud | 4.5 N.m |
| Blower Assembly Mounting Nut (RPO C42) For a description of the RPO Code(s) shown in this component refer to the RPO Code List found at Vehicle/Application ID | 4.5 N.m |
| Blower Assembly Mounting Screw/Bolt (RPO C42) For a description of the RPO Code(s) shown in this component refer to the RPO Code List found at Vehicle/Application ID | 4.5 N.m |
| Blower Assembly Mounting Stud (RPO C42) For a description of the RPO Code(s) shown in this component refer to the RPO Code List found at Vehicle/Application ID | 4.5 N.m |
| Blower Motor Access Cover Screw/Bolt (RPO C60 and C68)) For a description of the RPO Code(s) shown in this component refer to the RPO Code List found at Vehicle/Application ID | 2.5 N.m |
| Blower Motor Mounting Bolts | 4.5 N.m |
| Blower Motor Relay Bracket Mounting Screw/Bolt | 1.9 N.m |
| Blower Motor Resistor Mounting Screw/Bolt | 1.9 N.m |
| Body Harness Connector (C203) Support Bracket Mounting Nuts | 9.0 N.m |
| Compressor Discharge Hose to Condenser Fitting | 28 N.m |
| Compressor Pressure Relief Valve | 9 N.m |
| Compressor Suction/Discharge Hose to Compressor Bolt | 33 N.m |
| Compressor Suction Hose to Accumulator Fitting | 48 N.m |
| Condenser Insulator Retaining Screw/Bolt | 1.9 N.m |
| Electric Actuator (Temperature) Retaining Screw/Bolt | 1.9 N.m |
| Evaporator and Blower Module Mounting Nut | 4.5 N.m |
| Evaporator and Blower Module Mounting Screw/Bolt | 4.5 N.m |
| Evaporator Case Section to Blower Case Section Retaining Screw/Bolt | 1.9 N.m |
| Evaporator Tube Clip Screw/Bolt | 1.9 N.m |
| Evaporator Tube to Condenser Fitting | 28 N.m |
| Evaporator Tube to Evaporator Fitting | 28 N.m |
| Heater Core Access Cover Screws | 1.9 N.m |
| Heater Inlet and Outlet Hoses Bracket Bolt to Generator | 25 N.m |
| Heater Inlet and Outlet Hoses Bracket Bolt to Generator Mounting Bracket | 50 N.m |
| Floor Air Outlet Mounting Screw/Bolt | 1.9 N.m |
| Heater Inlet Hose Fitting at Intake Manifold | 23.5 |
| Heater/Vent Module Mounting Nut | 4.5 N.m |
| Heater/Vent Module Mounting Screw/Bolt | 4.5 N.m |
| Throttle Control Cable Bracket Nut | 12 N.m |