Air Cleaner Housing: Service and Repair
AIR CLEANER ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
1. Loosen the air cleaner outlet resonator clamp at the mass air flow/intake air temperature (MAF/IAT) sensor.
2. Remove the outlet resonator from the MAT/IAT sensor.
3. Disconnect the MAF/IAT sensor electrical connector (4).
4. Remove the air cleaner by pulling upward until the mounting studs are free from the grommets.
INSTALLATION PROCEDURE
1. Install the air cleaner by pressing downward until the grommets are seated.
2. Connect the MAF/IAT sensor electrical connector (4).
3. Install the outlet resonator to the MAT/IAT sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Tighten the air cleaner outlet duct clamp at the MAF/IAT sensor.
Tighten
Tighten the clamp to 4 N.m (35 lb in).