Oil Level Sensor: Service and Repair
Engine Oil Level Sensor and/or Switch ReplacementRemoval Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
Vehicle Lifting
2. Remove the drain plug and drain the oil into a suitable container.
3. Disconnect the oil level sensor electrical connector (7).
4. Remove the oil level sensor.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
Fastener Notice
1. Install the drain plug.
Tighten the plug to 25 Nm (18 ft. lbs.).
2. Install the oil level sensor.
Tighten the sensor to 20 Nm (15 ft. lbs.).
3. Connect the oil level sensor electrical connector (7).
4. Lower the vehicle.
5. Fill the engine with the proper quantity and grade of oil.