Pilot Bearing: Service and Repair

Pilot Bearing Replacement

^ Tools Required
- J 43276 Clutch Pilot Bearing Remover
- J 3BB36 Bushing Installer/Clutch Arbor

Removal Procedure

Notice: When using the J 43276 Clutch Pilot Bearing Remover always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so will cause damage to the J 43276-1 tool body.

Important: The flywheel spacer (if applicable) must be removed prior to clutch pilot bearing removal.





1. Remove the clutch assembly.
2. Using J 43276 perform the following in order to remove the clutch pilot bearing:
2.1. Install the J 43276-1 into the clutch pilot bearing.
2.2. Using a wrench, secure the J 43276-1.
2.3. Insert the J 43276-2 into the J 43276-1.
2.4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
2.5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
2.6. Remove the J 43276-1 from the tool body.





3. Discard the old clutch pilot bearing.

Installation Procedure

Important: The flywheel spacer (if applicable) must be removed prior to pilot bearing installation.





1. Install a 5/8 inch washer (1) onto the J 3B836 or equivalent.
2. Install a NEW clutch pilot bearing (2) onto the tool.





3. Install the NEW clutch pilot bearing into the crankshaft using J 3BB36.





4. Inspect the clutch pilot bearing for proper installation.
5. Install the clutch assembly.