Steering Wheel Control Switch
STEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
1. Remove the steering wheel.
2. Remove the shroud retaining screws from the back of the steering wheel.
3. Remove the shroud from the steering wheel.
4. Position a blunt ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control switch from the steering wheel.
5. Disconnect the steering wheel control switch electrical connector.
6. Remove the steering wheel control switch from the steering wheel.
IMPORTANT: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.
INSTALLATION PROCEDURE
1. Position the steering wheel control switch to the steering wheel.
2. Connect the electrical connector to the steering wheel control switch.
3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.
4. Install the shroud to the steering wheel.
5. Install the shroud retaining screws to the steering wheel.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 2 N.m (18 lb in).
6. Install the steering wheel.