Intermediate Steering Shaft Bearing

Intermediate Steering Shaft Bearing Replacement

Tools Required
- J42640 Steering Column Anti-Rotation Pin

Removal Procedure

Notice: The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become centered, which may cause damage to the coil assembly.





1. Install the J42640 in the steering column lower access hole.
2. Remove the lower intermediate shaft.





3. Remove the power steering reservoir (3) mounting nuts (4). Position power steering reservoir out of the way.





4. Remove the cruise control module (3) mounting nuts (2). Position cruise control module out of the way.





5. Remove the intermediate shaft seal to the cowl mounting screws.





6. Pull the intermediate shaft seal down and remove the upper intermediate shaft to intermediate shaft bearing retaining bolt.





7. Remove the intermediate shaft bearing bracket retaining nuts.
8. Remove the intermediate shaft lower brace retaining nut.
9. Remove the intermediate shaft bearing from the studs on the cowl and disconnect the intermediate shaft bearing from the upper intermediate shaft.
10. Remove the intermediate shaft bearing.
11. Remove the intermediate shaft seal.

Installation Procedure





1. Install the intermediate shaft seal.
2. Connect the intermediate shaft bearing to the upper intermediate shaft.
3. Connect the intermediate shaft bearing to the studs on the cowl.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the intermediate shaft bearing lower brace retaining nut.
Tighten the nut to 30 Nm (22 ft. lbs.).
5. Install the intermediate shaft bearing bracket retaining nuts.
Tighten the nuts to 30 Nm (22 ft. lbs.).





6. Install the upper intermediate shaft to the intermediate shaft bearing retaining bolt.
Tighten the bolt to 30 Nm (22 ft. lbs.).





7. Install the intermediate shaft seal upper retaining screws.
Tighten the screws to 2 Nm (18 inch lbs.).





8. Reposition the cruise control module (3) and install the cruise control module mounting nuts (2).
Tighten the nuts to 5 Nm (44 inch lbs.).





9. Reposition the power steering reservoir (3) and install the power steering reservoir mounting nuts (4).
Tighten the nuts to 6.5 Nm (58 inch lbs.).
10. Install the lower intermediate shaft.





11. Remove the J42640 from the steering column lower access hole.