Defroster Door Replacement (Heat Only)
REMOVAL PROCEDURE1. Remove the heater/vent module. Service and Repair
2. Remove the heater/vent module screws.
3. Separate the heater/vent module.
4. Remove the mode actuator screws.
5. Remove the mode actuator (3).
6. Remove the mode actuator cam assembly (4).
7. Remove the defroster door lever (2).
8. Remove the defroster door (1).
INSTALLATION PROCEDURE
1. Install the defroster door (1).
2. Install the defroster door lever (2).
3. Install the mode actuator cam assembly (4).
4. Install the mode actuator (3).
5. Install the mode actuator screws.
6. Install the mode actuator screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
7. Install the heater/vent module halves.
8. Install the screws to the heater/vent module.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
9. Install the heater/vent module.