Receiver Replacement - Digital Radio
RECEIVER REPLACEMENT - DIGITAL RADIOREMOVAL PROCEDURE
IMPORTANT: Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock(r), and "XM Theftlock(r)" will display.
1. Remove the right side junction block from the I/P. Do not disconnect the electrical connectors.
2. Lower the I/P compartment door to the full open position.
3. From the junction block opening, remove the two retaining screws.
4. Pull the receiver and bracket assembly from the I/P compartment opening.
5. Disconnect the wire connector (1).
6. Disconnect the coaxial cables from the receiver.
7. Remove the receiver and bracket assembly from the I/P.
INSTALLATION PROCEDURE
1. Connect the coaxial cables.
2. Connect the wire connector (1).
3. Install the receiver and bracket assembly to the I/P.
4. Install the two retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.6 Nm (14 lb in).
5. Install the right side junction block to the I/P.
6. Close the I/P compartment door.
7. Perform the setup procedure for the digital radio receiver. Digital Radio Receiver Setup