15. Wiring Harness Removal

Wiring Harness Removal





1. Using a 30 - 32 mm (1 3/16 inch) deep well socket or box end wrench, depress the four tabs on internal wiring harness connector (1). With the tabs depressed, gently pop the connector into and through main housing (2) with the palm of the hand.





2. Disconnect internal wiring harness (2) from the following components:
^ A trim solenoid (7)
^ C ON/OFF shift solenoid (8).
^ B trim solenoid (6)
^ E ON/OFF shift solenoid (5)
^ D ON/OFF shift solenoid (4)
^ F trim solenoid (3)
^ Pressure switch assembly (9)
^ G Modulated Main solenoid (11)

3. Remove solenoid retainers (1) from solenoids (4) and (5).
4. Remove internal wiring harness (2) from main valve body (10).
5. Install solenoid retainers (1).