Transfer Case Input Shaft Seal Replacement
Transfer Case Input Shaft Seal ReplacementTools Required
^ J42738 Seal Installer
Removal Procedure
1. Remove the transfer case.
2. Using a flat-tipped screwdriver, remove the input shaft seal.
Installation Procedure
Important: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (away from the body of the transfer case).
1. Align the input seal evenly on the input shaft.
Important: The input shaft seal should be even with the surface of the transfer case after installation.
2. Using the J42738, install the input shaft seal.
3. Install the transfer case.
4. Check the fluid level, add fluid if necessary.