101. Cylinder Head Installation - Left

This article and/or image reflects the update called out in tsb # 06-06-01-006b Dated 04/02/2008

Cylinder Head Installation - Left

Tools Required
* J36660-A Torque/Angle Meter





Notice: The left and right cylinder head gaskets are not interchangeable. Improper placement of the cylinder head gasket will block coolant and oil passages. Blocked coolant and oil passages will cause severe engine damage.

1. Install the left cylinder head gasket of the correct grade. The left and right cylinder head gaskets are not interchangeable. Refer to Cylinder Head Gasket Selection.
2. Install the left cylinder head.





Notice: This component uses bolts with a preapplied molybdenum disulfide coating for thread lubrication Do not remove the coating or use any additional lubricant. Improperly lubricated threads will adversely affect the bolt torque and clamp load. Improper bolt torque and clamp load can lead to engine damage

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the NEW M12 cylinder head bolts. Reuse the M8 bolts.
Tighten the M12 cylinder head bolts in three steps:
3.1. 1st step 50 Nm (37 ft. lbs.)
3.2. 2nd step 80 Nm (59 ft. lbs.)
3.3. 3rd step tighten 60 degrees using J36660-A
3.4. 4th step tighten 60 degrees using J36660-A
4. Tighten
Tighten the M8 cylinder head bolts to 25 Nm (18 ft. lbs.).