Parking Brake Warning Switch: Service and Repair

Park Brake Warning Lamp Switch Replacement

Removal Procedure






Caution: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
2. Remove the MID-bussed electrical center from the bracket.
3. Disconnect the park brake warning lamp switch electrical connector.






4. Remove the park brake warning lamp switch-mounting bolt.
5. Remove the park brake warning lamp switch.

Installation Procedure

1. Install the park brake warning lamp switch.

Note: Refer to Fastener Notice in Cautions and Notices.

2. Install the park brake warning lamp switch-mounting bolt.
- Tighten the bolt to 3 N.m (25 lb in).






3. Connect the park brake warning lamp switch electrical connector.
4. Install the MID-bussed electrical center to the bracket.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.