Operation CHARM: Car repair manuals for everyone.

B1397



DTC B1397

CIRCUIT DESCRIPTION
The body control module (BCM) provides a constant output reference voltage of 5 volts for the proper operation of the ambient light sensor. The constant output reference voltage supply ensures that variations in the output signal of the ambient light sensor are due to changes of the sensor rather than variations in the voltage supply. The BCM monitors the constant output reference voltage and sets a DTC when the output is not within the expected range of 4.75-5.25 volts.

DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC B1397 Device Voltage Reference Output Circuit Low

CONDITIONS FOR RUNNING THE DTC
- The system voltage must be between 9-16 volts.
- The ignition switch must be in the RUN position.
- The park brake must be released.
- The headlamp switch must be in the AUTO position.

CONDITIONS FOR SETTING THE DTC
- When the 5-volt reference output circuit is less than 4.75 volts or shorted to ground
- The above conditions are met for 0.5 second.

ACTION TAKEN WHEN THE DTC SETS
The daytime running lamps (DRL) feature will not operate.

CONDITIONS FOR CLEARING THE DTC
- The DTC will clear on current status after the condition for setting the fault is corrected.
- A history DTC will clear after 100 consecutive ignition cycles without a fault present.
- A scan tool may be used to clear history and current DTCs.

DIAGNOSTIC AIDS
- A short to ground in the 5-volt reference circuit will only cause this DTC to be set.
- Perform a visual inspection for loose or poor connections at all related components.

TEST DESCRIPTION

Steps 1 - 11:




Steps 12 - 13:




The numbers below refer to the step numbers on the diagnostic table.
2. This step tests for the proper operation of the circuit in the low voltage range.
3. This step tests for the proper operation of the circuit in the high voltage range. If the fuse in the jumper opens when you perform this test, the signal circuit is shorted to ground.
4. This step tests for a short to voltage in the 5-volt reference circuit.