B2648
DTC B2648
CIRCUIT DESCRIPTION
The body control module (BCM) monitors the courtesy lamp relay coil control circuit in order to determine if the daytime running lights (DRL) or the auto headlights (ALC) should be turned ON in the AUTO mode. When the BCM senses the ambient light sensor voltage is between 1.7-4.7 volts, the DRL will be commanded ON. When the BCM senses the ambient light sensor voltage is between 0.2-1 volt, the ALC will be commanded ON.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC B2648 Ambient Light Sensor Circuit High
CONDITIONS FOR RUNNING THE DTC
- The system voltage must be between 9-16 volts.
- The ignition switch must be in the RUN position.
- The park brake must be released.
- The headlamp switch must be in the AUTO position.
CONDITIONS FOR SETTING THE DTC
- When the ambient light sensor input voltage is greater than 4.78 volts.
- The courtesy lamp relay coil control circuit is shorted to the battery.
- The above conditions must be met for 0.5 second.
ACTION TAKEN WHEN THE DTC SETS
The ALC will remain ON in any ambient light state.
CONDITIONS FOR CLEARING THE MIL/DTC
- This DTC will clear immediately after the condition for setting the fault is corrected.
- A history DTC will clear after 100 consecutive ignition cycles without a fault present.
- Use a scan tool in order to immediately clear history and current DTCs.
DIAGNOSTIC AIDS
Perform a visual inspection for loose or poor connections at all related components.
TEST DESCRIPTION
Steps 1 - 10:
Steps 11 - 14:
The numbers below refer to the step numbers on the diagnostic table.
3. This step tests for the proper operation of the circuit in the low voltage range.
4. This step tests for the proper operation of the circuit in the high voltage range. If the fuse in the jumper opens when you perform this test, the signal circuit is shorted to ground.
5. This step tests for a short to voltage in the 5-volt reference circuit.
13. After replacement of the BCM, you must calibrate the new module for proper operation.