Garnish Molding Replacement - Upper Roller Track

GARNISH MOLDING REPLACEMENT - UPPER ROLLER TRACK

TOOLS REQUIRED
J 38778 Door Trim Pad and Garnish Clip Remover

REMOVAL PROCEDURE
1. Remove the retaining screws from the upper garnish molding.




2. Use J 38778 in order to release the molding retainers.

INSTALLATION PROCEDURE




1. Align the fasteners with the slots in the body.
2. Press the panel firmly into position, ensuring that all fasteners are fully seated.
3. Install the retaining screws to the upper garnish molding.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the retaining screws to the upper garnish molding to 2 Nm (18 lb in).